Little add to wish list (Map series)

sicorspa · Post by **sicorspa** » Tue Feb 03, 2009 8:02 am

Hello all,
I don't know if it's just added to the wish list, but i have found that with loadmap function, passing a TTable it's necessary to set it to the first record, otherwise it loads all the series value from the record where it is and repeat the last record until the end of the series.

It will be good to make the loadmap to auto-set to first record inside the procedure, and when it ends reset to the record where it was before.

Many thanks
Manuel

Narcís · Post by **Narcís** » Mon Feb 09, 2009 4:39 pm

Hi Manuel,

I don't think it is. I have just added it.