colorGrid series - getting started

wdsr · Post by **wdsr** » Tue Jun 26, 2007 4:48 pm

Hi

I wanting to use the colorgrid series functionality to plot binned data. However, the data "resolution" will be every 0.05 or 0.1 rather than every 1.

How do I alter the axes to my scale rather than the unit scale that the colorgrid series expects. For instance, is it possible to put on a dummy grid along with dummy axes to show my scale? My scale will always be a factor of the binned data - the data will be binned every x centimetres (eg 1, 5, 10) whereas I want the axes to be shown in metres.

Or, should I be using a different series!

I'm using v7.07.

Thanks

Narcís · Post by **Narcís** » Wed Jun 27, 2007 7:18 am

Hi wdsr,

At this thread you'll find information on how ColorGrid series works.

Regarding axes settings, I strongly recommend you to read Tutorial 4 - Axis Control. You may need to set a custom axis increment.

Hope this helps!

wdsr · Post by **wdsr** » Wed Jun 27, 2007 11:30 am

Thanks, it was the irregulargrid setting that I required. This negates my need for custom axes.

However, I had been attempting to draw custom axes but can not get them to appear. Could you also tell me where to find Tutorial 4 - I have search everywhere but I obviously have a blind spot!

William

Narcís · Post by **Narcís** » Wed Jun 27, 2007 1:09 pm

Hi William,

You'll find the tutorials at TeeChart's program group created by the binary installer. Only binary installers contain documentation and examples, source code installer only contains the full sources.

Tutorial 4 also explains how to use custom axes.