Steema Central

Hi Steema,

I have downloaded and tried running the TeeChart Pro for Delphi XE 3 installer on Windows 7 Pro 64bit. It gets to 100% but then pops up a message saying I need to manually re-install it.
I have seen a few messages about other users having problems with the Standard Version but I am trying to install the Pro version.

Any ideas of what the problem might be ?
I have an attached screenshot of the two messages I get at the end of the install.

Regards,
Steve

Hi,

This is a problem identified for the PreRelease for XE3:
http://www.teechart.net/support/viewtop ... =3&t=13648

However, it should have been fixed with the release published yesterday.
Is this the version you are using?

Hi Yeray,

Actually the one I downloaded said it was published/released on 26th October. I checked again this afternoon and it was still showing the same release date in my client logon area ?
Is there somewhere else I should be downloading it from ?

This was the Pre release version but I can see there is a full version released November 6th. I will try downloading that one instead.

Regards,
Steve

Hi Steve,

I checked again this afternoon and it was still showing the same release date in my client logon area ?
Is there somewhere else I should be downloading it from ?

No, it should be that. Try refreshing the page or clearing your browser cache just in case it's not updating.

This was the Pre release version but I can see there is a full version released November 6th. I will try downloading that one instead.

Yes, that's the final version, build number 2012.07.121105.

Hi Narcís ,

All good. The final release worked perfectly.

Thanks,
Steve

Hi Steve,

Thanks for your feedback!