Legend shows only one point

Rob · Post by **Rob** » Mon Feb 05, 2007 12:49 pm

Hello, this graph shows two sets of data from the same datasource. The down triangle points of the top line (Blue, Series name "Eis") are shown in the legend. The green line's (Series name "Fout") up triangle points are NOT shown in the graph. I first created the blue line, then cloned it to the green line and changed the X value.

The triangle for "Fout" is not shown in the Dialog.

For both series "show in legend" is switched on.

If in Chart Legend I change the settings Legendstyle from Series Names to series Values and set the Text style to Left value the legend shows 2 subsequent values both with the down triangle.

Why can't both lines be shown?

Rob

Narcís · Post by **Narcís** » Mon Feb 05, 2007 2:32 pm

Hi Rob,

Which exact TeeChart version are you using and in which environment are you using it? It would be very helpful if you could send us a simple example project we can run "as-is" to reproduce the problem here.

You can post your files at news://www.steema.net/steema.public.attachments newsgroup or our upload page at http://www.steema.net/upload.

Thanks in advance.

Rob · Post by **Rob** » Tue Feb 06, 2007 2:44 pm

Hi Narcis,

we use Delphi 6.0 with teechart 6.01.
Sending our entire project is not possible. If really, really needed we can isolate this particular problem and recreate a program that we can send.

Rob

Rob · Post by **Rob** » Tue Feb 06, 2007 3:20 pm

Narcis,

by coincedence the problem is solved. See small picture.

In the editor if held in the red circle the cursor changes into a hand with finger.

When doubleclicked a dialog with a colorscale is shown. If I click a color and click OK the up triangle is shown and everything works fine! Strange huh?

Rob