displaying individual failure marks

myghetto · Post by **myghetto** » Wed Dec 13, 2006 1:04 am

Hi,
I am currently comparing two series where one will be the default and the other is tested for failures. I would like individual marks to appear at the point of failure and display 'Failed' when it fails compared to the default series. Is this possible?
David

Narcís · Post by **Narcís** » Wed Dec 13, 2006 9:13 am

Hi David,

My colleague Marjan has replied to the thread you started about the same issue in the VCL forums.

If you have any problem porting Marjan's suggestion to the ActiveX version don't hesitate to post it here.