Once I place a Tchart in an Access form, and run and save it...
I can't seem to change the size in design view.
It will let me drag to a new size, but when it runs, it goes back to the original size.
In the Properties window, if I change the Height or Width property, the value goes back to the previous value when I press Enter.
What's going on?
Chart won't resize in Access
-
Productivity Guy
- Newbie
- Posts: 21
- Joined: Tue Mar 01, 2005 5:00 am
- Location: Spokane, WA
- Contact:
-
Narcís
- Site Admin
- Posts: 14730
- Joined: Mon Jun 09, 2003 4:00 am
- Location: Banyoles, Catalonia
- Contact:
Hi Productivity Guy,
This is quite strange, but to resize a chart you can do it doing:
1) Open the form in design view.
2) Click somewhere in the form but out of the chart. This will make the chart turn white.
3) Resize the chart.
4) Click on the chart to set it again to it's original appearence.
5) Run the form.
Doing those steps should let you resize your chart.
This is quite strange, but to resize a chart you can do it doing:
1) Open the form in design view.
2) Click somewhere in the form but out of the chart. This will make the chart turn white.
3) Resize the chart.
4) Click on the chart to set it again to it's original appearence.
5) Run the form.
Doing those steps should let you resize your chart.
Best Regards,
| Narcís Calvet / Development & Support Steema Software Avinguda Montilivi 33, 17003 Girona, Catalonia Tel: 34 972 218 797 http://www.steema.com |
      |
| Instructions - How to post in this forum |