I'm repeating this bulk of this post in a new thread in order to make sure its better disseminated to the community. It originally was in the thread "Suppression of Format Tabs in Run-Time Chart Editor" for more info. ---- This is the same problem I reported over two years ago (Nov 2002) but appare...

I found the problem...it is the same problem I reported over two years ago but apparently has still not been fixed. The units I was using used other units which used other units, etc, etc, until eventually, somewhere in my project, was a unit which used QDialogs. For some reason QDialogs is incompat...

I'm sorry, perhaps I wasn't clear. The four problematic units are ones which I created. The problem is as follows. As a test, I created an application which only has a TChart and a TChartEditor on it. The chart contains a single Point3D series. Clicking on the chart brings up the editor. TeeEditPro ...

Note: TeeChart 6 w/Delphi 7 I've been having problems getting the format tab(s) to show up in the run time chart editor for certain series (e.g., Point3D). Adding TeeEditPRO has had no effect. I remember in older versions of TeeChart, there were problems where using certain Delphi units would suppre...